Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Jon Elson
 
Posts: n/a
Default Update on Suzuki engine



Ignoramus21002 wrote:

A police detective called me. I told him the full fedex story. After
realizing that I will not be home during his working hours, he asked
me to get a VIN number off the engine. He said that it should be there
in at least 3 places (any ideas where?)



I doubt the number on a motorcycle engine is in 3 places. Maybe on the
WHOLE
motorcycle it will be in 3 places, but you don't have all of that. Look
it over
with a bright light for numbers that are STAMPED into a flat space on
the metal.
It should be a pretty long sequence that goes
letter-letter-number-letter-letter
and then continues for 14-17 total characters.

Jon

Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Update on Suzuki engine Pete Snell Metalworking 5 January 18th 18 03:18 PM
Someone sent me a Suzuki engine Andy Asberry Metalworking 3 October 27th 05 07:02 AM
Someone sent me a Suzuki engine Pete Snell Metalworking 0 October 26th 05 04:16 PM
Someone sent me a Suzuki engine Jim Stewart Metalworking 0 October 26th 05 12:56 AM
(Toro) Suzuki 2-cycle engine question TomKan Home Repair 9 April 22nd 05 01:06 AM


All times are GMT +1. The time now is 06:30 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"