How does one refill the hydrastatic drive in a Gilson-built, Monty Ward
'72 lawn tractor ?

any help appreciated- where's the fill plug ?

if there a special procedure ?

thanks in advance

well, since nobody else is answering, I'll add my little bit of wisdom,
or lack of it:

I don't know anything about this particular tractor, but the
hydrostatic drives GENERALLY have a fill plug somewhere on the
hydraulic tank - the tank may be under the access panel on the floor in
front of the seat. If you're not sure, the plug will probably be a
round plug with a square socket in the top that a 1/2" or 3/8" drive
ratchet will fit. If the plug is not on top, it may be on the side of
the tank and doubles as a level-check hole (when oil reaches the height
of the hole, it's full - much like a rear-end on a rwd truck or car).
Sorry for a lack of specifics, I really don't know this brand of lawn
tractor, but no one else seems to be attempting to help.

thanks

On 9 Dec 2005 10:26:32 -0800, "DesertBob Jr."
wrote:

How does one refill the hydrastatic drive in a Gilson-built, Monty Ward
'72 lawn tractor ?

any help appreciated- where's the fill plug ?

if there a special procedure ?

thanks in advance

You got one of those pieces of **** too?
I got one myself. Constantly breaking down...
The speed is terrible, I can walk faster than that thing.
I'm pretty much ready to junk it except the engine.
I'll look on mine and see if I can figure out where to fill, but cant
do it today.

Gotta run

Mark