| Home |
| Search |
| Today's Posts |
|
#1
Posted to alt.electronics
|
|||
|
|||
Atmega8 to drive a motor
Hi,
I looking at driving a half amp 12v pump from an atmega8 or 168 through a mosfet. What is the recommended mosfet for this application? I have done heaps of snooping online but am getting quite bamboozled. Thanks in advance, regards Darren |
|
#2
Posted to alt.electronics
|
|||
|
|||
|
Atmega8 to drive a motor
Hi,
I looking at driving a half amp 12v pump from an atmega8 or 168 through a mosfet. What is the recommended mosfet for this application? I have done heaps of snooping online but am getting quite bamboozled. how many volts VCC to the atmega? (how many to ground?) what's the stall current of the pump? or how high does current spike when starting? are you switching low side or high side of the pump supply? 12V negative to ground? Bye. Jasen |
|
#3
Posted to alt.electronics
|
|||
|
|||
|
Atmega8 to drive a motor
"Jasen Betts" wrote in message news:g5fet0$dv2$4@gonzo... Hi, I looking at driving a half amp 12v pump from an atmega8 or 168 through a mosfet. What is the recommended mosfet for this application? I have done heaps of snooping online but am getting quite bamboozled. how many volts VCC to the atmega? (how many to ground?) 5 what's the stall current of the pump? 0.46A or how high does current spike when starting? ??? are you switching low side or high side of the pump supply? High 12V negative to ground? No Bye. Jasen |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| WTD: BA5983FP Motor Drive IC | Electronics Repair | |||
| DC motor drive with voltage boost | Metalworking | |||
| Traveling Irrigator drive motor | Metalworking | |||
| I/O-ing Frequencies on ATMega8 | Electronics | |||
| DC motor and drive, can I reverse it by changing wires? | Metalworking | |||
Linear Mode
