At my last job before we got the SMT equipment up and running we soldered
SMT parts by hand. For resistors, put some solder on one pad, keep molten,
and with tweezers slide it into place. Then solder the other side. With
chips, anchor one or two corner pins with solder, then do the rest, and
reflow the first. I even had to solder the real fine pitch ones using only
the very tip of a 10W iron. I'm not sure what the actual pin size was, but
maybe about 2 pixels wide if held up to the screen. Soldering SMT by hand
is tricky, but you just gotta go slow.



wrote in message
om...
Hi,
Im just starting to build some boards specifically using MCU's
and other components, some of the components I wish to use only come in
fine pitch SMT packages. I have looked into reflow and how the
components are normally attached to boards using solder past (solder
cream) and then put though a oven that controls the heating up and
reflow and cool down process carefully. I noticed that most components
im looking at have a heat up to 150° C at 1 to 3 degrees a second to
ensure not to damage the component. Now as far as I can see I only have
2 options to using such components:
1.) build a small reflow oven that is computer controlled and can be
programmed based on the components Im using, this option is not
expensive but is extremely time consuming.
2.) pay for a shop to fabricate the boards (which is expensive when
dealing with small quantities).

I was wondering if its possible to place such components using a hot
air pencil, but these will obviously heat the component up very
quickly, based on the reflow specs I assume this would damage the
components?

Any other fast and not so expensive options?

Thanks for your time.