Home |
Search |
Today's Posts |
#1
Posted to alt.electronics
|
|||
|
|||
Press n peel - double sided
Anyone got any good tips for doing a good quality double sided board?
My current thinking is to drill two large holes in the board pre-marking and line up the holes with circles in the peel film. Any tips welcome! J |
#2
Posted to alt.electronics
|
|||
|
|||
Press n peel - double sided
On 2006-03-23, Coyoteboy wrote:
Anyone got any good tips for doing a good quality double sided board? chinese fab houses offer good deals for small runs. My current thinking is to drill two large holes in the board pre-marking and line up the holes with circles in the peel film. I'd use small holes and pins to line it up. Bye. Jasen |
#3
Posted to alt.electronics
|
|||
|
|||
Press n peel - double sided
Jasen Betts fleurde mijn beeldscherm op met hetvolgende:
On 2006-03-23, Coyoteboy wrote: Anyone got any good tips for doing a good quality double sided board? chinese fab houses offer good deals for small runs. My current thinking is to drill two large holes in the board pre-marking and line up the holes with circles in the peel film. I'd use small holes and pins to line it up. Bye. Jasen I place to strips of PCB between the sheets. They will have the same thickness as the PCB, you can easily hold it against the light to see if you lined them up correctly. One thing should be said, this only works fine if you can illuminated both side of the PCB at the same time. -- Alexander _______________________________________ Nationalism is an infantile sickness. It is the measles of the human race. - Albert Einstein |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
double sided sticky pads | UK diy | |||
double sided sticky pads | UK diy | |||
Mobile base for a drill press | Woodworking | |||
Mortiser vs. Drill Press | Woodworking | |||
Sell or Trade Rockwell 17" drill press - old and good | Metalworking |