Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Maybe I should ask this question again. on a Toshiba.
I have a Toshiba CF26C30 Chassy# TAC9360 I'm looking for the value for
R327. its burnt up. I replaced the Vert output. and the caps in the vert circuit. The resistor comes off the 1 amp fuse from the Vert IC. Thanks.. Mike. |
#2
|
|||
|
|||
Maybe I should ask this question again. on a Toshiba.
Somebody already answered your question, but here it is again; 5.6 ohms
|
#3
|
|||
|
|||
Maybe I should ask this question again. on a Toshiba.
Well I got a service manual for the set today, and to my suprise it
was a 5.6ohm resistor. Thanks for the info. Got the set running. On Wed, 05 Nov 2003 13:22:20 -0500, JW wrote: On 05 Nov 2003 04:35:39 GMT (TV Fixer1) wrote in Message id: : Somebody already answered your question, but here it is again; 5.6 ohms I doubt it's the correct answer, as "john" posted that before Mike specified the correct reference designation. (assuming their clocks are reasonably close.) |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
chemistry question | Metalworking | |||
Toshiba TP50H15 Dead | Electronics Repair | |||
Toshiba Rear Projection TV convergence and power problem | Electronics Repair | |||
Pipe thread question, NPT vs NPSF, MIP, FIP and IPS | Metalworking |