Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
Peavey CS800S, slave amp 1997
Light weight as switch mode power supply. Not dared to power up yet but is
there any problem concerning the power supply with runnung one power amp only, disconnecting the rails to the other amp, either for low power or high power audio throughput. How and what is the function of the 2x3 inch board on the casing bottom , between outlet section and ps, that presumably is a power or overload monitor and runs 3 wires back to the ps. It has a Motorola TO126 labelled 715 (MJE715 ?) and 2 x 400R and little else. What do the 3 wires do ? switch off both ps sections or one at a time? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Master/Slave mains sockets | UK diy | |||
Peavey XR 886, 1997, mixer amp | Electronics Repair | |||
WTB: Slave power mains socket strips | UK diy | |||
Final master / slave socket dies ;-( | UK diy | |||
Wireless slave light switch | UK diy |