 |
|
| Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#9
Posted to alt.comp.hardware.pc-homebuilt,alt.comp.hardware,sci.electronics.design,sci.electronics.repair
|
|||
|
|||
Adding missing SATA connectors to motherboard
On Jan 10, 9:57 am, "larry moe 'n curly"
wrote: I have some motherboards designed for 4-6 SATA ports, but only 2 SATA connectors were installed, and I'd like to add the missing connectors plus any needed termination resistors. Here's an example with an ECS GeForce 6100SM-M v. 1.0 motherboard: http://farm4.static.flickr.com/3397/...b349938d_o.jpg What are the values of the missing resistors? I thought that each pair of SATA data lines needed one 100 ohm resistor between them, but on this circuit board the resistors seem to be arranged differently. Hello, I am not an expert, but the caps you see are the coupling caps. The termination resistor would be at the end of the line, not the middle. I'm not sure what the value of the cap would be, but 100nF is a good start. I could be wildly wrong about the value, I know nothing of the SATA specs. |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Rain missing gutter due to rotten/missing felt | UK diy | |||
| Sata power cable | Electronics Repair | |||
| Motherboard fuses - missing? | Electronics Repair | |||
| Source for crimp on SATA power connectors? | Electronics | |||
| Anyone use a Sata Minijet 2 to spray furniture. | Woodworking | |||
Threaded Mode
