Home |
Search |
Today's Posts |
![]() |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]()
Loss of reverb effects. But of course when I try it all present and correct.
Other than attending to the usual suspects ,anyone know of a specific problem with these? Presumably unconnected problem - anyone know what the 1.5x1.5x1 inch epoxied block is that has fallen (safely because of plastic housing) against the power transistors is, 5 wire ribbon connected ? Owner reports that the moveable notch filter has never worked. I try it with sig gen and operates over 120 to 1200 Hz , noticeably reducing the throughput. Is he likely top thing it should totally suppress at the chosen notch f ? . If I put a scope on it , what would the usual dB peak cut be of such a notch, generally speaking, not necessarilythis Trace amp? -- Diverse Devices, Southampton, England electronic hints and repair briefs , schematics/manuals list on http://home.graffiti.net/diverse:graffiti.net/ |
#2
![]()
Posted to sci.electronics.repair
|
|||
|
|||
![]() N Cook wrote in message ... Loss of reverb effects. But of course when I try it all present and correct. Other than attending to the usual suspects ,anyone know of a specific problem with these? Presumably unconnected problem - anyone know what the 1.5x1.5x1 inch epoxied block is that has fallen (safely because of plastic housing) against the power transistors is, 5 wire ribbon connected ? Owner reports that the moveable notch filter has never worked. I try it with sig gen and operates over 120 to 1200 Hz , noticeably reducing the throughput. Is he likely top thing it should totally suppress at the chosen notch f ? .. If I put a scope on it , what would the usual dB peak cut be of such a notch, generally speaking, not necessarilythis Trace amp? -- Diverse Devices, Southampton, England electronic hints and repair briefs , schematics/manuals list on http://home.graffiti.net/diverse:graffiti.net/ The notch f spread should be a tad lower. Don't know if the epoxied block is cutout/excess gain control or "Dynamic Correction" (TM) apparently for correcting speaker induced distortion in the pa. I assume the latter as TM and otherwise presumably unnecessary epoxy. The 5 wires are opamp +&- DC rails , pa and ps ground lines (about 0.2R between the two) and a line to the + i/p of the pa preliminary 071 op amp -- Diverse Devices, Southampton, England electronic hints and repair briefs , schematics/manuals list on http://home.graffiti.net/diverse:graffiti.net/ |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
RCA 31" 1994 - repair or replace? | Electronics Repair | |||
Acoustic Glass..... | UK diy | |||
Zenith TV 1994 model SM2568S picture compressed | Electronics Repair | |||
Herringbone pattern in video (Hitachi 46" PTV Model #: 46UX13K DOP: 1994) | Electronics Repair | |||
help on SONY 32inch TV, KV-32TS36 1994(in service date) | Electronics Repair |