Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.components,sci.electronics.repair
|
|||
|
|||
SN75500 plasma driver
Wasn't someone looking for one of these a little while back ?
http://cgi.ebay.co.uk/INTEGRATED-CIR...QQcmdZViewItem Graham |
#2
Posted to sci.electronics.components,sci.electronics.repair
|
|||
|
|||
SN75500 plasma driver
"Eeyore" wrote in message ... Wasn't someone looking for one of these a little while back ? http://cgi.ebay.co.uk/INTEGRATED-CIR...QQcmdZViewItem Graham yes, that was me (SN75518) but i can not find any datasheets on the SNJ55500EJ to see if in fact it will work unfortuneately i have allready invested lots of time in an Allegro 6818 PLCC to DIP convertor and about to install and test it but if it does not work then i would try one of those SNJ55500 well maybe i will get 1 anyways thanks for posting that, robb |
#3
Posted to sci.electronics.components,sci.electronics.repair
|
|||
|
|||
SN75500 plasma driver
On Oct 11, 1:42 am, "robb" wrote:
"Eeyore" wrote in ... Wasn't someone looking for one of these a little while back ? http://cgi.ebay.co.uk/INTEGRATED-CIR...SN75500-PLASMA... Graham yes, that was me (SN75518) but i can not find any datasheets on the SNJ55500EJ to see if in fact it will work SN55500EJ datasheet should give you the spec (SNJ is just the MIL/QML Qualified version of the standard SN part) http://www.datasheetarchive.com/preview/3148803.html Hope this is some help. |
#4
Posted to sci.electronics.components,sci.electronics.repair
|
|||
|
|||
SN75500 plasma driver
wrote in message ps.com... On Oct 11, 1:42 am, "robb" wrote: "Eeyore" wrote in ... Wasn't someone looking for one of these a little while back ? http://cgi.ebay.co.uk/INTEGRATED-CIR...SN75500-PLASMA... Graham yes, that was me (SN75518) SN55500EJ datasheet should give you the spec (SNJ is just the MIL/QML Qualified version of the standard SN part) http://www.datasheetarchive.com/preview/3148803.html Hope this is some help. Lots of Help, Thank you apparently it is a better chip than what i am using thanks again, robb |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Bosch 10.8v I-driver | Woodworking | |||
Driver Bits | UK diy | |||
Experiences with the Parker Metalworking Plasma-Tec40/160yk plasma cutter/TIG welder/arc welder? | Metalworking | |||
drill-driver vs magazine driver £200 budget | UK diy | |||
Triangular screw driver bit? | UK diy |