Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
Grundig TV MFW70-2410/7
When switched on: sound and picture appears. E/W amplitude is too
small, Focus is not correct, HOT T504 (2SC5331) runs very hot, R536 (6.8R 1W) runs very hot. The TVset switches to SBY (protection mode) after aprox 6 seconds. When reapplying power the same event happens. Running the set on a ballast lamp with HOT disconnected shows no problems, B+ however is believed to be a little low (130 VDC rather than 148 VDC) Could the HV transformer be defective ? other suspects ? TIA Bram |
#2
Posted to sci.electronics.repair
|
|||
|
|||
Grundig TV MFW70-2410/7
In data Sun, 25 Jun 2006 16:33:09 +0200, BRASTO ha
scritto: When switched on: sound and picture appears. E/W amplitude is too small, Focus is not correct, HOT T504 (2SC5331) runs very hot, R536 (6.8R 1W) runs very hot. The TVset switches to SBY (protection mode) after aprox 6 seconds. When reapplying power the same event happens. Running the set on a ballast lamp with HOT disconnected shows no problems, B+ however is believed to be a little low (130 VDC rather than 148 VDC) Could the HV transformer be defective ? other suspects ? Oh, maybe if you say the chassis number... TIA Bram -- Inty.Evolution - per email normali e con immagini Jpeg |
#3
Posted to sci.electronics.repair
|
|||
|
|||
Grundig TV MFW70-2410/7
In data Sun, 25 Jun 2006 16:33:09 +0200, BRASTO ha
scritto: When switched on: sound and picture appears. E/W amplitude is too small, Focus is not correct, HOT T504 (2SC5331) runs very hot, R536 (6.8R 1W) runs very hot. The TVset switches to SBY (protection mode) after aprox 6 seconds. When reapplying power the same event happens. Running the set on a ballast lamp with HOT disconnected shows no problems, B+ however is believed to be a little low (130 VDC rather than 148 VDC) Could the HV transformer be defective ? other suspects ? Hello, Beko 22.1 chassis as you wrote in Sts Board TIA Bram -- Inty.Evolution - per email normali e con immagini Jpeg |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Grundig TV Arganto 82 MW 82-500 IRDT | Electronics Repair | |||
Grundig cuc-2030 chassis | Electronics Repair | |||
meaning of button symbols on a grundig tv | Electronics Repair | |||
grundig flyback problem | Electronics Repair | |||
Help with Grundig systems? | Electronics Repair |