Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
RCA ITC800FBK RANDOM DEAD
My first ITC800 chassis. Just got it in and bench tested it. It held up
for an hour or so then went dead (didn't see if the pic went wide before it died) . I hear that the pincushion module can cause shutdown problems and that there is a service bulletin for it. Could someone post the essentials of the bulletin or post the link where I could find it. Any tips (other than from RW) would be greatly appreciated. Thanks, Mark |
#2
|
|||
|
|||
Check the pincushion correction wires (two) going from
the main board to the pincushion board on the right side of the chassis. Solder the connections, & "slightly" pry the pins to give a bit more tension, unless they are burn, then cut the wires, & solder directly. Try this site. You need a login, but you may be able to get in. Sky. http://thomsonnetwork.com/documents/..._tech_info.htm |
#3
|
|||
|
|||
Complete PCC assembly may be available as a replacment part.
"Skype_man" wrote in message ... Check the pincushion correction wires (two) going from the main board to the pincushion board on the right side of the chassis. Solder the connections, & "slightly" pry the pins to give a bit more tension, unless they are burn, then cut the wires, & solder directly. Try this site. You need a login, but you may be able to get in. Sky. http://thomsonnetwork.com/documents/..._tech_info.htm |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
OT - Blue & Red | Metalworking | |||
OT - 386 code | Metalworking | |||
Ever turn a dead leprechaun?!? | Woodturning | |||
Dead Leprechaun Coffins | Woodworking | |||
SmartUPS dead? | Electronics Repair |