Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Mitsubishi Television...Can't Turn It On Reliablely
I have a 27" Mitsubishi television from the mid 90's that will not turn
on reliablely. One must turn it on dozens of times before it will stay on. I have noticed that it is used often, the problem goes away while if it is not used for weeks the problem becomes more severe. I have checked the archives and it does sound like the known capacitor problem with Mitsubishi sets of the 90's raising its ugly head. While the set is a very nice set which works great after getting it turned on and it does have sentimental value, I seriously doubt that it is worth going through if one needs to replace hundreds of caps. The main question I have for the group is does anyone know why the set refuses to turn on? Does anyone know the failure mode that is going on? Is this a common symptom? My sister had a similar set of comparable age with the same problem. Thanks for any advice. TMT |
#2
|
|||
|
|||
"Too_Many_Tools" wrote in message oups.com... I have a 27" Mitsubishi television from the mid 90's that will not turn on reliablely. One must turn it on dozens of times before it will stay on. I have noticed that it is used often, the problem goes away while if it is not used for weeks the problem becomes more severe. I have checked the archives and it does sound like the known capacitor problem with Mitsubishi sets of the 90's raising its ugly head. While the set is a very nice set which works great after getting it turned on and it does have sentimental value, I seriously doubt that it is worth going through if one needs to replace hundreds of caps. The main question I have for the group is does anyone know why the set refuses to turn on? Does anyone know the failure mode that is going on? Is this a common symptom? My sister had a similar set of comparable age with the same problem. Thanks for any advice. TMT You shouldn't have to replace hundreds of caps, the Mits cap issue is the PiP board and is a couple dozen caps, that board can be removed and bypassed if you don't use that feature. The power issue is probably a capacitor in the power supply or a cold solder joint, the repair should be fairly simple and straightforward, I do suggest you stop using the set until it's fixed though, those quick power cycles are hard on it. |
#3
|
|||
|
|||
Thanks for the response.
It does have PIP but I have never used it. Considering that the set has never shown the symptom before and is very seldom used, I suspect it is a capacitor problem. Thanks for pointing out the abuse that the quick power cycles are doing...I will not cycle it again. I really hate to just toss the set since the television is still a quality set. When I compare it to the current offerings, one can easily see the quality differences that have been made in the market. Where would you suggest one go to get the schematic for this set? Is SAMS still around? TMT |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Mitsubishi CS-20SX1, intermittent start up. | Electronics Repair | |||
How to Adjust the Tape Path Alignment on Newer VCRs | Electronics Repair | |||
ATT; Hobbyists and Repairmen I have accumulated a room of ICS, Transistors, Diodes , Mem Chips , Proms etc | Electronics Repair | |||
Help needed to Akai television | Electronics Repair | |||
Faulty Beko Television | Electronics Repair |