Porter Cable says they include one of these with their 7216 Ominjig, and it
is needed to cut 1/2" dovetails.
My new Omnijig did not have one, and when I complained to PC, they said it
was discontinued and not available.

I am trying to find one, and cannot; the only ones I find are the same size
on both cutter and bearing. Where can I buy such a thing?

If you cannot find one I think a 9/16 bearing and bit will do if you replace
the bearing with a 1/2 x 5/8 or get a 1/4 inch shank and get a 14 x 5/8
bearing. I went the other way. I have a lathe and I made a sleeve that is
9/16 x 5/8 and pressed it over the bearing.
max

Porter Cable says they include one of these with their 7216 Ominjig, and it
is needed to cut 1/2" dovetails.
My new Omnijig did not have one, and when I complained to PC, they said it
was discontinued and not available.

I am trying to find one, and cannot; the only ones I find are the same size
on both cutter and bearing. Where can I buy such a thing?

You can buy bearings seperate from bits- I got a tin full of bearings.


-Dan V.



On Wed, 22 Dec 2004 05:35:47 GMT, "toller" wrote:

Porter Cable says they include one of these with their 7216 Ominjig, and it
is needed to cut 1/2" dovetails.
My new Omnijig did not have one, and when I complained to PC, they said it
was discontinued and not available.

I am trying to find one, and cannot; the only ones I find are the same size
on both cutter and bearing. Where can I buy such a thing?