Just got 240V service in the garage. I'll get around to rewiring the saw
from 110 to 220V.

I *recall* hearing or reading from someone that the wiring diagram in the
manual or on the motor was incorrect.

[ Or maybe the comment was they were amazed that it was correct.]

I forget.
Me n' Dory suffer from short term memory loss. It runs in our family. Or at
least we think it does...


Before I embark on this - has anyone here rewired the saw from 110 to 220V?
If so - are there any words of wisdom I need to keep in mind?

Thank you!

"patrick conroy" wrote in message
...

I *recall* hearing or reading from someone that the wiring diagram in the
manual or on the motor was incorrect.

My Jet saw manual was correct. The Jet drill press manual was incorrect.
Both tools had a diagram inside the motor housings which were accurate. My
dealer says always go by what's in the motor housing.

Before I embark on this - has anyone here rewired the saw from 110 to
220V?
If so - are there any words of wisdom I need to keep in mind?

If you are not sure of yourself on what to do, get some help. Its a simple
job but not something you want to mess up. Also get over the reluctance of
changing the plug on your precious tool. Just grab your side cutters and
whack it off. It doesn't hurt very long.

Bob

On Fri, 22 Oct 2004 10:52:02 GMT, "Bob"
wrote:




"patrick conroy" wrote in message
...

If you are not sure of yourself on what to do, get some help. Its a simple
job but not something you want to mess up. Also get over the reluctance of
changing the plug on your precious tool. Just grab your side cutters and
whack it off. It doesn't hurt very long.


Thanks Bob!