"patrick conroy" wrote in message
...

I *recall* hearing or reading from someone that the wiring diagram in the
manual or on the motor was incorrect.

My Jet saw manual was correct. The Jet drill press manual was incorrect.
Both tools had a diagram inside the motor housings which were accurate. My
dealer says always go by what's in the motor housing.

Before I embark on this - has anyone here rewired the saw from 110 to
220V?
If so - are there any words of wisdom I need to keep in mind?

If you are not sure of yourself on what to do, get some help. Its a simple
job but not something you want to mess up. Also get over the reluctance of
changing the plug on your precious tool. Just grab your side cutters and
whack it off. It doesn't hurt very long.

Bob