| Home |
| Search |
| Today's Posts |
 |
|
Menu
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
DJ-20 table sag: alignment instructions?
When my infeed table is even with the cutters (right adjacent to the
cutters), the infeed table is higher then the cutters at the far end of the infeed table. Since the DJ-20 has a parallelogram mechanism, the way you adjust it must be different from the general methods I have seen published. Is there a set of instructions specifically for fixing sag in DJ-20 tables? Thanks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| I have limited space, need a table that will accomodate different tools that I can adjust to the height of my workbench | Woodworking | |||
| An Ultimate Router Table - Part I: A Short Story | Woodworking | |||
| How Wide Should an Outfeed Table be? | Woodworking | |||
| How to Adjust the Tape Path Alignment on Newer VCRs | Electronics Repair | |||
| New bandsaw saga PartII (long) | Woodworking | |||
Threaded Mode
