About Us

DerbyDad03

On Saturday, April 6, 2019 at 12:14:46 PM UTC-4, Leon wrote:
On 4/5/2019 11:57 AM, wrote:
On Fri, 5 Apr 2019 11:09:57 -0500, Leon lcb11211@swbelldotnet wrote:

On 4/5/2019 6:30 AM, Greg Guarino wrote:
On Wednesday, April 3, 2019 at 11:22:27 AM UTC-4, Leon wrote:

Yex, I do not cut close to the line, I let the router take a full width
cut and go deeper with each pass.

What size bit do you typically use? And another ignorant question:
As the bit will have wood on both sides, which direction do you move the router?
I'm going to guess that it doesn't matter, but that I should keep it consistent.

IIRC I used a 1/2" bit. I went counter clockwise for a lazy Susan piece
that I did a couple of years ago. In your case I would go clockwise.
You typically want the bit to be cutting away from the piece you want to
keep.

Shouldn't that be leading cutter rotating into
the piece you want to keep ?
.. experiment on a scrap piece to be sure ..
John T.

OK, so with the router bit facing down the bit spins clockwise. When
cutting a circle and you want to keep the circle, you want to keep the
convex part of the cut, the router should go counter clockwise.

When keeping the concave side of the cut the router should be going
clockwise.

Going in the direction described above the bit will resist feed. If you
go in the opposite direction for both operations above the bit will try
to climb into the cut.

Basically you want the bit to be cutting/pulling away from the keeper side.

And that fits with the "right hand rule". [ I think ;-) ]

With the palm down of your right hand facing down and the thumb and
index finger held at 90Â°, your thumb points at the edge that you want
to rout (or in this case, keep) and your index finger points in the
direction that you should move the router.

To keep the circle, your thumb would point towards the center of the
circle therefore your index finger would point to the right, which
would be counter-clockwise.

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
For soft carriers, make sure that it's washable and has adjustablestraps. This allows you to keep the same great fit as your baby grows. Yourbaby should fit snugly, and have good head support, and their weight should beevenly distributed. Only use a	[email protected]	Home Ownership	0	April 19th 08 09:16 PM
For soft carriers, make sure that it's washable and has adjustablestraps. This allows you to keep the same great fit as your baby grows. Yourbaby should fit snugly, and have good head support, and their weight should beevenly distributed. Only use a	[email protected]	Electronics Repair	0	April 19th 08 11:42 AM
Request for help finding a cam curve that will have lower maximum contact stress than a Parabolic curve (and link to CAD and JPEG files)	John2005	Metalworking	19	March 31st 06 04:30 AM
Advice to keep cars from sliding into my yard on bad curve.	Don	Metalworking	148	November 30th 04 07:45 PM
How to make a fair curve?	Bay Area Dave	Woodworking	44	February 18th 04 01:19 PM

Menu

About Us