On 4/5/2019 6:30 AM, Greg Guarino wrote:
On Wednesday, April 3, 2019 at 11:22:27 AM UTC-4, Leon wrote:


Yex, I do not cut close to the line, I let the router take a full width
cut and go deeper with each pass.

What size bit do you typically use? And another ignorant question: As the bit will have wood on both sides, which direction do you move the router? I'm going to guess that it doesn't matter, but that I should keep it consistent.


IIRC I used a 1/2" bit. I went counter clockwise for a lazy Susan piece
that I did a couple of years ago. In your case I would go clockwise.
You typically want the bit to be cutting away from the piece you want to
keep.