Hello, I have a Wadkin Burgsgreen table saw. It is missing its Metric miter guage. The width is 20 mm. The depth is 11 mm. Can someone tell me where to purchase one?
thanks,
Al

Al Zajec wrote:
Hello, I have a Wadkin Burgsgreen table saw. It is missing its Metric
miter guage. The width is 20 mm. The depth is 11 mm. Can someone tell me
where to purchase one?
thanks,
Al




If you can't find one, get a regular 3/4" one, epoxy a thin strip
of oak or maple to the side and sand to fit. The depth is close enough.

--
G.W. Ross

I didn't cheat, I just changed the Rules!

On 6/23/2012 12:54 PM, Al Zajec wrote:
Hello, I have a Wadkin Burgsgreen table saw. It is missing its Metric
miter guage. The width is 20 mm. The depth is 11 mm. Can someone tell me
where to purchase one?
thanks,
Al





http://www.incra.com/product_miter_v27.htm

Contact manufacturer to make sure the git will be right. These bars are
adjust to git.

On 6/24/2012 11:12 AM, Leon wrote:
On 6/23/2012 12:54 PM, Al Zajec wrote:
Hello, I have a Wadkin Burgsgreen table saw. It is missing its Metric
miter guage. The width is 20 mm. The depth is 11 mm. Can someone tell me
where to purchase one?
thanks,
Al





http://www.incra.com/product_miter_v27.htm

Contact manufacturer to make sure the git will be right. These bars are
adjust to git.


git = Fit ;~)

On 6/25/2012 7:24 AM, Leon wrote:
On 6/24/2012 11:12 AM, Leon wrote:
On 6/23/2012 12:54 PM, Al Zajec wrote:
Hello, I have a Wadkin Burgsgreen table saw. It is missing its Metric
miter guage. The width is 20 mm. The depth is 11 mm. Can someone tell me
where to purchase one?
thanks,
Al





http://www.incra.com/product_miter_v27.htm

Contact manufacturer to make sure the git will be right. These bars are
adjust to git.


git = Fit ;~)

Git it right, you git! :-)

--
Any given amount of traffic flow, no matter how
sparse, will expand to fill all available lanes.
To reply, eat the taco.
http://www.flickr.com/photos/bbqboyee/