Hey Guys,
What do you think of this "accessory" to the Domino? Say you want to
match up a rail to a leg or post and the indexing pins on the Domino
are not suitable for any number of reasons. Do you think that if
there were some domino shaped centering devices-similar to those dowel
ceter makers-that these might aid you in lining up where to put the
mating slot? The device could have a small protruding pin that would
put its mark slightly above the top plane of the slot so you could
locate the position with the tool's cursor.
Anyway, it was just a thought- and I already sent it to Festool so you
can't scoop me on this.
Marc

"marc rosen" wrote in message
...
Hey Guys,
What do you think of this "accessory" to the Domino? Say you want to
match up a rail to a leg or post and the indexing pins on the Domino
are not suitable for any number of reasons. Do you think that if
there were some domino shaped centering devices-similar to those dowel
ceter makers-that these might aid you in lining up where to put the
mating slot? The device could have a small protruding pin that would
put its mark slightly above the top plane of the slot so you could
locate the position with the tool's cursor.
Anyway, it was just a thought- and I already sent it to Festool so you
can't scoop me on this.
Marc

Cool thought but, The Domino can be lined up free hand the same way a
biscuit joiner is lined up. Make a mark on the wood at the center point of
the mortise to be cut and line that up with the center mark on the fence
window.