As mentioned in a previous post, I am adding 1/4" Oak panelling about
4 ft high around my entranceway.

I would like to use a single sheet running along the two sidewalls which
are each 52" long. I can do this if I buy a 4x10 sheet (which is
available), cut it in half, and run each half horizontally along the
sidewalls.

However, this would make the grain run *horizontally*.
Would this look "wrong" for panelling?
(I am assuming that grain usually runs vertically on panelled walls)

Otherwise I would presumably need to have a seam (covered by a style)
since it doesn't seem like the oak veneer plywood comes in widths
wider than 4 ft and I need 4ft 4inches.

Thanks.

Fri, Oct 19, 2007, 2:44pm (EDT+4) (blueman) doth
wonder:
snip However, this would make the grain run *horizontally*. Would this
look "wrong" for panelling? snip

If it will bother you, then yes, it will look wrong. If it won't
bother you, then no, it won't look wrong. That was easy, wasn't it? By
the way, your car color looks wrong, get it repainted.



JOAT
"I'm an Igor, thur. We don't athk quethtionth."
"Really? Why not?"
"I don't know, thur. I didn't athk."

Just my 2 cents, but an undivided sheet of plywood (no matter how fancy the
veneer) is still going to look like plywood. If you want it to look like
pannels, you should run stiles to divide up the space (even if they are
purely aesthetic and glued to the face of the sheet) This would also allow
you to use a single sheet of vertically oriented ply to cover the space as
some area will be consumed by stiles.

-Steve


"blueman" wrote in message
...
As mentioned in a previous post, I am adding 1/4" Oak panelling about
4 ft high around my entranceway.

I would like to use a single sheet running along the two sidewalls which
are each 52" long. I can do this if I buy a 4x10 sheet (which is
available), cut it in half, and run each half horizontally along the
sidewalls.

However, this would make the grain run *horizontally*.
Would this look "wrong" for panelling?
(I am assuming that grain usually runs vertically on panelled walls)

Otherwise I would presumably need to have a seam (covered by a style)
since it doesn't seem like the oak veneer plywood comes in widths
wider than 4 ft and I need 4ft 4inches.

Thanks.


--
Posted via a free Usenet account from http://www.teranews.com

On Fri, 19 Oct 2007 14:44:52 GMT, blueman wrote:

However, this would make the grain run *horizontally*.
Would this look "wrong" for panelling?
(I am assuming that grain usually runs vertically on panelled walls)

Otherwise I would presumably need to have a seam (covered by a style)
since it doesn't seem like the oak veneer plywood comes in widths
wider than 4 ft and I need 4ft 4inches.

I'm not going to say it's wrong to run the grain horizontally but I
wouldn't run it that way.
You mention putting a stile in the middle. You could also put a stile
at each end (instead of one in the middle) large enough so the 1/4"
could run under it and still pick up your length.

Mike O.