On Feb 19, 9:00 am, ROY! wrote:
I have a 1/2", 10" x 10" or so flat aluminum plate that I'd like to
use to mount a router in my router table. Problem is the aluminum is
not anodized so I'm concerned it will mark the wood. I'm thinking of
gluing formica to the top of the plate. Anyone have alternate
suggestions? Thanks.

Roy!

formica glue to aluminum can be a bit tricky. do a bit of reading of
the can label to make sure you have the right glue. if your shop has
wide temp swings differential expansion may give you flatness
problems. otherwise, it should work fine.