Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.woodworking
|
|||
|
|||
Will this fit tighten with glue?
I am using some coat pegs that measure 0.493". That is a pretty sloppy fit
in a 0.500" hole, but other than hoping I can find an undersized drill bit, I am not sure what to do about it. Presumably the glue will swell the pieces a bit; but will it be enough for a secure installation? The pegs are a bit too expensive to waste one on a test. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Weeping rad' valve, can I tighten it ? | UK diy | |||
Galvanized steel pipes - tighten how much? | Home Repair | |||
How to Tighten Front Door | Home Repair | |||
Using trigger to tighten Panasonic chuck | Woodworking | |||
How to tighten a cistern valve? | UK diy |