Yep, that's similar to the idea I had as well. I was just going to use
some sort of a tong device, but your idea would work as well.

KS wrote:
In article , says...

Yes that worked really well. Unfortunately the disk still rides up with
the bit so I have to stop the press and take off the disc, but I was
wondering how I was going to get the disc out of the MDF anyway since it
was such a tight fit. I nice clean hole at least.


How about drilling a hole in another board slightly smaller than the
disk. Then use that board on top of the disk to hold it down in the mdf
that your using now. Maybe?