I am looking at putting a router table extension on the right side of my
left tilt hybrid TS. I want to use a 24" table to replace the right wing.
If I do, the router will fit with maybe an inch of clearance from the motor
shroud. I would not have the ability to rotate the router more than 30
degrees or so. Will that cause any problems for me? I can't think of how
it would. It appears that I would have access to all the controls in that
position.

-Steve

Steve W wrote:
I am looking at putting a router table extension on the right side of my
left tilt hybrid TS. I want to use a 24" table to replace the right wing.
If I do, the router will fit with maybe an inch of clearance from the motor
shroud. I would not have the ability to rotate the router more than 30
degrees or so. Will that cause any problems for me? I can't think of how
it would. It appears that I would have access to all the controls in that
position.

-Steve

it might work, but it sounds like a pain in the butt. I'd give it a
little more room- at least enough to pass your hand with a tool like a
screwdriver or something held in it . otherwise I think you're gonna be
smacking your knuckles down there.