Home |
Search |
Today's Posts |
|
Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.woodworking
|
|||
|
|||
What to do about my jerky PC333?
I have 4 PC333s. One of them has started jerking and jumping around. I
have read that the common problem is a small belt breaking, so I pulled the bottom off and found the belt was fine. However, the little pulley it goes around was seized. I removed it, cleaned it, and lubed it. It turns now. (I just wish I had understood it screwed the wrong direction before I stripped the threads out.) The sander is about 50% better, but still not right. Any ideas? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Mitsubishi HS-u53 VCR has jerky picture | Electronics Repair |