I have a Delta 34-444 contractors saw. Can one purchase cast iron
extensions to replace the stamped extensions? Has anyone done this?

In article . com,
"Jerry" wrote:

I have a Delta 34-444 contractors saw. Can one purchase cast iron
extensions to replace the stamped extensions? Has anyone done this?

Jerry

I did this a few years ago for my 444 saw. I got it through Amazon.
Sorry, can't remember how much it cost--something around $80.00 comes to
mind.

dp

--

www.brndogwoodworks.com

On 9 Feb 2006 11:22:44 -0800, "Jerry" wrote:

I have a Delta 34-444 contractors saw. Can one purchase cast iron
extensions to replace the stamped extensions? Has anyone done this?

Check deltamachinery.com to find the part number and your local
dealer.

Mike O.

Delta standardized on a 10" cast iron wing and it fits everything from the
unisaw to the contractor to the shaper at about $90. Any Delta vendor
should be able to get you 1, or 2. The higher end contractors only come
with a left CI wing and a table board on the right side.

"Mike O." wrote in message
...
On 9 Feb 2006 11:22:44 -0800, "Jerry" wrote:

I have a Delta 34-444 contractors saw. Can one purchase cast iron
extensions to replace the stamped extensions? Has anyone done this?

Check deltamachinery.com to find the part number and your local
dealer.

Mike O.

"Jerry" wrote in message
ups.com...
I have a Delta 34-444 contractors saw. Can one purchase cast iron
extensions to replace the stamped extensions? Has anyone done this?



I bought the cast iron wing as well for my 444. About $90. I like it.
(Sorry about the email - learning new software)

Steve LaBroad