| Home |
| Search |
| Today's Posts |
 |
|
Menu
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Router help needed.
I have a PC 8529 variable speed soft start router. It is very clean and
hasn't had much use. The motor speed is all over the place and it sometimes stops. The brushes and com commutater are clean. Any suggestions? max |
|
#2
|
|||
|
|||
|
Router help needed.
I would suspect the variable speed electronics.
Does it act differently if you set the speed control to maximum ? If it is still in warrenty consider sending it in for repair. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Where to position router plate | Woodworking | |||
| Router Station in Table Saw Extension | Woodworking | |||
| 2-1/4 or 3 HP router for floating tenons and dovetail jig? | Woodworking | |||
| Router bit help needed | Woodworking | |||
| source needed - steel router bit v-groove | Woodworking | |||
Linear Mode
