| Home |
| Search |
| Today's Posts |
 |
|
Menu
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Router sizing question
I am building a computer controlled router and will need to cut through
3/4" pine. If I use a router rather than a spiral saw, what horsepower rating should I consider? I'd like to cut at 2-3 in/sec. Thanks, John |
|
#2
|
|||
|
|||
|
Check the Shopbot website. They use a 3.5hp Porter Cable and I seem to
rcall a 3.5" pre sec feed rate as being a good starting point. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Router Question | Woodworking | |||
| Question about using a bull nose router bit in a router table | Woodworking | |||
| Router Question | Woodworking | |||
| An Ultimate Router Table - Part I: A Short Story | Woodworking | |||
| Question about using a router | UK diy | |||
Linear Mode
