Hey All;
I just bought a Woodcut Bowlsaver at the woodworking show here in
KC and I have a question about the proper way to set the depth of cut.
It came with the layouts for this nifty little jig that you can use
(the video shows how), but what if your blanks are deeper than the
fixed template? It says in the video that you can get bowls from stock
up to 6" deep, but I can't figure out how. Anyone else have experience
with this system? I searched the rec and found nothing and the woodcut
site is apparently in the middle of an upgrade. Any help would be
appreciated.

thanks....Alex