I have a block of Lignum Vitae 10"Wide by 6" Deep and need to cut off
a piece to turn.
It is too thick for the table saw , I'm not trying a hand saw!
Do I cut it with a chain saw?

wrote in news:tlr3g1d4rh36drs2aopsnjkjlgel1hq9s6@
4ax.com:

I have a block of Lignum Vitae 10"Wide by 6" Deep and need to cut off
a piece to turn.
It is too thick for the table saw , I'm not trying a hand saw!
Do I cut it with a chain saw?

That new band saw you wanted? Here's justification!

Patriarch

On Tue, 16 Aug 2005 13:52:04 GMT, wrote:

I have a block of Lignum Vitae 10"Wide by 6" Deep and need to cut off
a piece to turn.
It is too thick for the table saw , I'm not trying a hand saw!
Do I cut it with a chain saw?

How about, make a cut on your table saw, turn it over and cut the same
track from the opposite side, then use your handsaw to saw down the
kerf and finish it?


--
Chuck *#:^)
chaz3913(AT)yahoo(DOT)com
Anti-spam sig: please remove "NO SPAM" from e-mail address to reply.


September 11, 2001 - Never Forget

----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----

Got a friend with a bandsaw? No? Might be a good time to make a new
friend. Or visit a local high school woodshop (if there are any left)!

Barry


wrote in message
...
I have a block of Lignum Vitae 10"Wide by 6" Deep and need to cut off
a piece to turn.
It is too thick for the table saw , I'm not trying a hand saw!
Do I cut it with a chain saw?