Home |
Search |
Today's Posts |
|
UK diy (uk.d-i-y) For the discussion of all topics related to diy (do-it-yourself) in the UK. All levels of experience and proficency are welcome to join in to ask questions or offer solutions. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Probably dumb bathtap drilling Q
So I have new Acrylic bath, new mixer tape for it with what I'm sure
is 3/4BSP threaded tails. (To be connected to 22mm pipe) And I need to drill holes in the bath to make it fit. What size drill do I need? Or do I use a hole saw sort of thing? The chuck on my Bosch is only 13mm too... All advice appreciated! Gordon |
#2
|
|||
|
|||
|
#3
|
|||
|
|||
In message , Gordon Henderson
writes So I have new Acrylic bath, new mixer tape for it with what I'm sure is 3/4BSP threaded tails. (To be connected to 22mm pipe) And I need to drill holes in the bath to make it fit. What size drill do I need? Err, big enough for the tail to fit through? 22-25mm I guess without measuring a fitting. Or do I use a hole saw sort of thing? Hole saw is probably best, but I've drilled them ok with a spade type wood bit. Just don't go to fast. The chuck on my Bosch is only 13mm too... Doesn't mater, the shafts of the drills etc. are sized small enough to fit. All advice appreciated! Gordon -- Chris French, Leeds |
#4
|
|||
|
|||
On Wed, 25 Aug 2004 13:22:45 +0000, Gordon Henderson wrote:
So I have new Acrylic bath, new mixer tape for it with what I'm sure is 3/4BSP threaded tails. (To be connected to 22mm pipe) And I need to drill holes in the bath to make it fit. What size drill do I need? Or do I use a hole saw sort of thing? The chuck on my Bosch is only 13mm too... All advice appreciated! Gordon 28mm hole saw. You might get away with 26mm but you'll need to be very accurate with the hole centres. (180mm centre to centre IIRC). -- Ed Sirett - Property maintainer and registered gas fitter. The FAQ for uk.diy is at www.diyfaq.org.uk Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html |
#5
|
|||
|
|||
In article .uk,
Ed Sirett wrote: On Wed, 25 Aug 2004 13:22:45 +0000, Gordon Henderson wrote: So I have new Acrylic bath, new mixer tape for it with what I'm sure is 3/4BSP threaded tails. (To be connected to 22mm pipe) And I need to drill holes in the bath to make it fit. What size drill do I need? Or do I use a hole saw sort of thing? The chuck on my Bosch is only 13mm too... All advice appreciated! Gordon 28mm hole saw. You might get away with 26mm but you'll need to be very accurate with the hole centres. (180mm centre to centre IIRC). Thanks for all the replies! Gordon |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
SDS drilling, tips on how to use. | UK diy | |||
Drilling through a steel pipe. | Metalworking |