On Wed, 25 Aug 2004 13:22:45 +0000, Gordon Henderson wrote:

So I have new Acrylic bath, new mixer tape for it with what I'm sure
is 3/4BSP threaded tails. (To be connected to 22mm pipe)

And I need to drill holes in the bath to make it fit.

What size drill do I need? Or do I use a hole saw sort of thing? The
chuck on my Bosch is only 13mm too...

All advice appreciated!

Gordon

28mm hole saw. You might get away with 26mm but you'll need to be very
accurate with the hole centres. (180mm centre to centre IIRC).




--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html