On Wed, 25 Aug 2004 13:22:45 +0000 (UTC),
(Gordon Henderson) wrote:
hi gordon,
yes you re correct the hole saw is best for this, 1'' size as i
recall, (check the size) use the starret brand types, use a 4mm pilot
hole first then drill nice and slowly finishing off with a half round
file
regards
bob
So I have new Acrylic bath, new mixer tape for it with what I'm sure
is 3/4BSP threaded tails. (To be connected to 22mm pipe)

And I need to drill holes in the bath to make it fit.

What size drill do I need? Or do I use a hole saw sort of thing? The
chuck on my Bosch is only 13mm too...

All advice appreciated!

Gordon