Andrew Wrote in message:
On 15/11/2019 07:17, Jimk wrote:
Paul Giverin Wrote in message:
On 14/11/2019 21:06, Adrian Brentnall wrote:
On 14/11/2019 19:21, Paul Giverin wrote:
About 25 years ago we had a small utility room built on to our
kitchen. Its only about 1.5m x 1.5m internally and two of the four
walls are part of the existing house, i.e cavity brick/block. The
other two walls are single brick exposed to the elements. All the
walls are bare brick internally. Nothing has been plastered. It has
always suffered from some condensation on the single brick walls but
this year we splashed out and replaced the original single glazed door
and window with efficient sealed units.

With the onset of colder weather, the condensation seems to have got
worse. I was thinking about tanking/insulating the inside of the
single brick walls. When you take away the window and the door, there
is only 3 or 4 square meters of single brickwork. I was considering
simply attaching some insulated plasterboard (link below) to the
internal single brickwork using a grab adhesive. Will this plan work?


https://www.travisperkins.co.uk/ther...-38mm/p/383834


Thanks

That's what that plasterboard is designed for (I used to work for the
company that made it, back in the '70s.
You'll lose a small amount of space from the room - but it will make the
walls warmer.
Using the tapered-edge board you can achieve a fairly neat / invisible
join between the boards - there's a tape that goes into the taper before
you apply the filler, to prevent cracks later.

Thanks for that. To be honest, I'm not too worried about how good it
looks. Its only a utility room for appliances and currently is painted
brick. I'll probably just be painting the plasterboard in the same
colour as the rest of the room. I was just worried about the grab
adhesive being up to the job.


There's always expanding foam made for fixing plasterboards?


Alternatively, do as I did to the lounge and bedroom walls facing
North. Use 30mm 'celotex' cut to the exact height of the room and
fix to the wall using battens cut down from cls timber. This
gives three battens 30mm thick. Fix these horizontally using
80mm frame anchors, then infill between the battens with more
30mm 'celotex' (I used Quinntherm).


Sounds like a lot of farting about whilst introducing cold bridges
& vapour channels into the previously contiguous insulation
....

Then affix plasterboard to
the battens, scim if needed or use tapered PB with glassfibre
reinforcing.

There are foaming PU adhesives for fixing plasterboard, but you
need to check that it doesn't disolve the extruded polystyrene
on the back of the plasterboard.

Polystyrene?
The ones linked to & the only ones worth bothering with are PIR foam...

--
Jimk


----Android NewsGroup Reader----
http://usenet.sinaapp.com/