History:
3 weeks ago machine (Candy GO 1482) stopped working, with help from
here it was the carbon brushes. Now 2 weeks later i get an error code 8
according to google.

€¢ Check motor connector block
€¢ Check wiring
€¢ Check tacho connections
€¢ Check motor

Now that certainly coincides with me taking the motor out and replacing
the brushes however I am sure the connections were ok.
As just recently out of hospital I wont be able to haul the machine out
for a few days so just trying to get a checklist ready.
I can recheck connections however is there anything else I can check at
that time? Other than checking connections I am at a loss.

Basically what happens is cycles start and then eventually end up on the
flashing error code.
The machine drains spins individually but not as part of the programmed
cycle.