Home |
Search |
Today's Posts |
|
UK diy (uk.d-i-y) For the discussion of all topics related to diy (do-it-yourself) in the UK. All levels of experience and proficency are welcome to join in to ask questions or offer solutions. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to uk.d-i-y
|
|||
|
|||
flue sealing for a Baxi WM 381
A friend has just has been advised that her boiler is unsafe as the sealing
around the balance flue is inadequate. Is there an easy remedy for this. Is it as simple as injecting a heat-proof sealant around the existing flue is is it indicative of a more serious installation problem? Tim |
#2
Posted to uk.d-i-y
|
|||
|
|||
flue sealing for a Baxi WM 381
More information would be a help here.
Make and model of boiler. Where is the problem? Flue ducting, boiler conection , around teminal, brickwork etc. --- Posted via news://freenews.netfront.net/ - Complaints to --- |
#3
Posted to uk.d-i-y
|
|||
|
|||
flue sealing for a Baxi WM 381
Whoops!
Just seen make and model in header. --- Posted via news://freenews.netfront.net/ - Complaints to --- |
#4
Posted to uk.d-i-y
|
|||
|
|||
flue sealing for a Baxi WM 381
Heliotrope Smith wrote:
Whoops! Just seen make and model in header. ;-) My friend has been advised that combustion prducts are re-entering the house, probably alongside the flue. There are small gaps in the rendering around the flue on the outside. Difficult to see if there's any problem elsewhere. Tim .. |
#5
Posted to uk.d-i-y
|
|||
|
|||
flue sealing for a Baxi WM 381
"Tim Downie" wrote in
: Heliotrope Smith wrote: Whoops! Just seen make and model in header. ;-) My friend has been advised that combustion prducts are re-entering the house, probably alongside the flue. There are small gaps in the rendering around the flue on the outside. Difficult to see if there's any problem elsewhere. Tim . Products of combustion spilling into the property would be immediatly dangerous and I would expect the gas operative to disconnect the boiler from the gas supply and cap the pipework. It should say on the paperwork left where the problem stems from. On that model the flue cannot be removed for inspection without removing the boiler first. If it is proved that combustion gas is getting in between the air intake and the building fabric then repointing around the flue and render would be the cure. A high temerature silicon such as 'Plumbaflue' would also make an acceptable seal. --- Posted via news://freenews.netfront.net/ - Complaints to --- |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Baxi WM 38/3 RS | UK diy | |||
Gas fire to fit on an external wall with a bent flue or a long (approx 1metre) flue | UK diy | |||
Sealing a flue | UK diy | |||
Kitchen Extractor Fan Flue Location & boiler Flue location | UK diy | |||
Back flue sealing plate ? | UK diy |