"Tim Downie" wrote in
:

Heliotrope Smith wrote:
Whoops!

Just seen make and model in header.

;-)

My friend has been advised that combustion prducts are re-entering the
house, probably alongside the flue. There are small gaps in the
rendering around the flue on the outside. Difficult to see if there's
any problem elsewhere.

Tim
.


Products of combustion spilling into the property would be
immediatly dangerous and I would expect the gas operative
to disconnect the boiler from the gas supply and cap the pipework.

It should say on the paperwork left where the problem stems from.

On that model the flue cannot be removed for inspection without
removing the boiler first.

If it is proved that combustion gas is getting in between the
air intake and the building fabric then repointing around the flue
and render would be the cure.

A high temerature silicon such as 'Plumbaflue' would also make an
acceptable seal.

--- Posted via news://freenews.netfront.net/ - Complaints to ---