If you have an existing feather edge fence with the arris rails going into
mortises on concrete posts, how to you replace the arris rails?

Removing the old ones is easy enough, but how do you get the new ones in?

Could use arris rail brackets fixed to the posts with plugs, but not keen on
that idea because drilling could leave the rebar susceptible to rust.


--
Dave - The Medway Handyman
www.medwayhandyman.co.uk

"The Medway Handyman" wrote:

If you have an existing feather edge fence with the arris rails going into
mortises on concrete posts, how to you replace the arris rails?

Removing the old ones is easy enough, but how do you get the new ones in?

Could use arris rail brackets fixed to the posts with plugs, but not keen on
that idea because drilling could leave the rebar susceptible to rust.


A blob of silicone or mastic sealant in the hole before you fit the
plug, then a blob in the plug before you fit the screw as insurance,
should do the trick.

"The Medway Handyman" wrote in message
...
If you have an existing feather edge fence with the arris rails going into
mortises on concrete posts, how to you replace the arris rails?

Removing the old ones is easy enough, but how do you get the new ones in?

Could use arris rail brackets fixed to the posts with plugs, but not keen
on that idea because drilling could leave the rebar susceptible to rust.


--
Dave - The Medway Handyman
www.medwayhandyman.co.uk


There are Galavanised steel end brackets available, made specially to
address the problem that you describe.
They have a steel "tenon" which goes into the concrete mortice on one end
and screw, with wood screws onto the end of the Arris rail.
I believe that they are normally used in pairs, one on each end, but I
suppose that you could get away with fitting them to one end only, maybe ?
If you had an email which was valid I could send you a photo of them in
situ. !!

Ian.

The Medway Handyman wrote:

If you have an existing feather edge fence with the arris rails going into
mortises on concrete posts, how to you replace the arris rails?

Removing the old ones is easy enough, but how do you get the new ones in?

Could use arris rail brackets fixed to the posts with plugs, but not keen
on that idea because drilling could leave the rebar susceptible to rust.


Are the mortises blind or through? If they are through then just taper one
end of the arris rail to overlap its opposite number and then pull it back
to the other mortise then tosh nail the overlap.

I do remember an american catalogue of tools from the 1800s that showed a
windlass for bowing a cleft chestnut rail to enable it to be fitted between
existing posts but I guess it would need to be green or steamed.

AJH