Hi,
I've noticed that when I run the shower (gainsborough energy 2000), the
bathroom light dims slightly then brightens when its switched off. It has
always done this, but I just wondered if this is normal?
Cheers,
Bramblestick

On Tue, 27 Mar 2007 22:05:51 GMT, "Bramble-Stick"
mused:

Hi,
I've noticed that when I run the shower (gainsborough energy 2000), the
bathroom light dims slightly then brightens when its switched off. It has
always done this, but I just wondered if this is normal?

It can be normal, and usually is.
--
Regards,
Stuart.

Bramble-Stick wrote:

I've noticed that when I run the shower (gainsborough energy 2000), the
bathroom light dims slightly then brightens when its switched off. It has
always done this, but I just wondered if this is normal?

Chances are it is probably normal. Showers place a very high current
load on the supply, which will in effect try to pull the voltage down a
bit. The more resistance there is in the wires supplying your property,
the more noticeable the voltage drop. Ordinary filament bulbs tend to
show up even quite small voltages changes as a change in brightness -
most noticeable when it is a big load that switched on or off.

(with our relatively "floppy" supply via overhead lines, even a 3kW
kettle will dim the lights a little)

--
Cheers,

John.

/================================================== ===============\
| Internode Ltd - http://www.internode.co.uk |
|-----------------------------------------------------------------|
| John Rumm - john(at)internode(dot)co(dot)uk |
\================================================= ================/

John Rumm wrote:
Bramble-Stick wrote:

I've noticed that when I run the shower (gainsborough energy 2000),
the bathroom light dims slightly then brightens when its switched off.
It has always done this, but I just wondered if this is normal?


Chances are it is probably normal. Showers place a very high current
load on the supply, which will in effect try to pull the voltage down a
bit. The more resistance there is in the wires supplying your property,
the more noticeable the voltage drop. Ordinary filament bulbs tend to
show up even quite small voltages changes as a change in brightness -
most noticeable when it is a big load that switched on or off.

(with our relatively "floppy" supply via overhead lines, even a 3kW
kettle will dim the lights a little)

and lights on a dimmer are evn more sensitive - you don't just get a
lower voltage but for a shorter duty cycle as well.

--
Spamtrap in use
To email replace 127.0.0.1 with btinternet dot com