Hi

I have a Heatline S30 Compact Boiler and I just wanted to make sure I
was setting things up correctly

The CH Temp control on the Boiler has an "e" mark (for highest
effiecency according to the manual). If the boiler is set to this,
which is quite high. I think it heats to about 70C if i remeber
correctly.

The Prog Room Stat should then be set to desired temps and times.

Is this the best setup? or should I leave the Boiler on low?

Thanks

On Mon, 08 Jan 2007 03:49:05 -0800, yshaikh01 wrote:

Hi

I have a Heatline S30 Compact Boiler and I just wanted to make sure I
was setting things up correctly

The CH Temp control on the Boiler has an "e" mark (for highest
effiecency according to the manual). If the boiler is set to this,
which is quite high. I think it heats to about 70C if i remeber
correctly.

The Prog Room Stat should then be set to desired temps and times.

Is this the best setup? or should I leave the Boiler on low?

Thanks

Set the boiler to the lowest setting that allows the radiators to heat the
house. If the boiler also heat the water with a cylinder then you will
need to set the boiler high enough to make that happen in a timely manner.
That means about 65-75C, i.e. about 10C more than the cylinder is set to.
HTH

--
Ed Sirett - Property maintainer and registered gas fitter.
The FAQ for uk.diy is at http://www.diyfaq.org.uk
Gas fitting FAQ http://www.makewrite.demon.co.uk/GasFitting.html
Sealed CH FAQ http://www.makewrite.demon.co.uk/SealedCH.html
Choosing a Boiler FAQ http://www.makewrite.demon.co.uk/BoilerChoice.html
Gas Fitting Standards Docs he http://www.makewrite.demon.co.uk/GasFittingStandards