I have posted earlier about my dishwasher which is not heating the water up and is getting stuck on two points in the cycle, it is a whirpool washer that must be over 10 years old (it was already installed in our new house). We were advised to check the element as this was the most likely problem, we have now done this and have found that the element is working fine. Has anybody got any suggestions on what to check next?

Thank you!

"Jmorg" wrote in message
...

I have posted earlier about my dishwasher which is not heating the water
up and is getting stuck on two points in the cycle, it is a whirpool
washer that must be over 10 years old (it was already installed in our
new house). We were advised to check the element as this was the most
likely problem, we have now done this and have found that the element
is working fine. Has anybody got any suggestions on what to check
next?

Is it integrated ? If so underneath is a resetable cut-out in the heating
circuit it is small and difficult to see.

"Jmorg" wrote in message
...

I have posted earlier about my dishwasher which is not heating the water
up and is getting stuck on two points in the cycle, it is a whirpool
washer that must be over 10 years old (it was already installed in our
new house). We were advised to check the element as this was the most
likely problem, we have now done this and have found that the element
is working fine. Has anybody got any suggestions on what to check
next?

Thank you!


--
Jmorg

Don't waste any money repairing a 10 year old Whirlpool when you can get a
new AAA superior one for just over £200...

http://www.currys.co.uk/product.php?...amp_id=froogle

Or better still pay a bit extra and get a Miele like I just have.

The dishwasher is a Whirpool ADG 710 - do you (or does anybody) happen to know where the cut out switch might be on this model - or does anybody have a system manual showing a picture of underneath?

Thanks