Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Bad spot on motor?
I bought a 1 ton Budgit 3 phase hoist at auction. Tried it today. Went up
and down a couple of times just fine. After that, the motor would only hum; no attempt at motion. I just tore it down. Nothing obviously wrong. What are the chances of a bad spot on the windings causing this? Any way to double check for this problem? Karl |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Coill winding / AC motor construction - book recommendation ? | Electronics Repair | |||
Repair data base | Electronics Repair | |||
Slow down a drill press: 2nd motor and use the existing motor as a countershaft? | Metalworking | |||
Knee mill motor problem... sigh. | Metalworking | |||
Well, well, well; Delta MAY have listened - the brand new 14 Band Saw now has a RESILIENT MOUNT motor! shades of yesteryear! | Woodworking |