 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Small stepper motor
I need to find some stepper motors about 3/8 inch in diameter to
drive a microscope stage. The length is not too much a factor as long as they are less than inch and half long. They need to be low profile because they will be on top of the stage. Does anyone have any ideas? Thanks Gordon Couger Stillwater, OK www.couger.com/gcouger |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Repair data base | Electronics Repair | |||
| How does a 110volt 2 speed motor work | Home Repair | |||
| Small motor wiring... | Metalworking | |||
| Slow down a drill press: 2nd motor and use the existing motor as a countershaft? | Metalworking | |||
| Knee mill motor problem... sigh. | Metalworking | |||
Threaded Mode
