Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Glue Guru update
Thanks all for some great ideas! The creativity and wisdom here is amazing
and much appreciated. Here's a new twist that looks good: I modified an air stapler (BEC brand) that shoots 18 ga. 1/4" x 1/2" staples. I extended the nose with a MIG weld and machined it into shape, I also modified the ram and punch so that the stapler now pushes the punch 1/2" beyond the elongated nose. I milled a slot in the nose to pick-up the flat wire and act as a centering index. With the stapler at a 20 deg angle, the staple follows the wire down after it leaves the nose and enters the wood right next to the original staple without "falling off" the punch. Taa-Daa!!! Pull-out now exceeds 60 pounds, probably closer to 100 but my pull-scale stops at 60....Good enough! It takes about 3 minutes per brush and the staples are $6/5,000. I'm looking at how to automate it but I only have @3,000 to do so, brute-force with a human looks good. Thanks again!!! |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Glue Guru needed | Metalworking | |||
Glue Up - High Anxiety | Woodworking | |||
About Hot Hide Glue | Woodworking | |||
If glue is stronger than the wood, do you need to use screws when attaching legs to a table? | Woodworking | |||
Popping glue lines | Woodworking |