Home |
Search |
Today's Posts |
![]() |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
![]()
Posted to rec.crafts.metalworking
|
|||
|
|||
![]()
lathe runs for about 30 mins then starts to slow down within 30 seconds it
stops as though a brake has been put on , leave it for 20 mins then its ok again until the next 30 mins very frustrating -- for full context, visit https://www.polytechforum.com/metalw...he-651613-.htm |
#2
![]()
Posted to rec.crafts.metalworking
|
|||
|
|||
![]()
On Wed, 17 Feb 2021 22:18:02 +0000, ian
wrote: lathe runs for about 30 mins then starts to slow down within 30 seconds it stops as though a brake has been put on , leave it for 20 mins then its ok again until the next 30 mins very frustrating The spindle bearing (tapered bushing) hasn't been properly lubricated / maintained and it is hot seizing. |
#3
![]()
Posted to rec.crafts.metalworking
|
|||
|
|||
![]()
On 17/02/2021 22:18, ian wrote:
lathe runs for about 30 mins then starts to slow down within 30 seconds it stops as though a brake has been put on , leave it for 20 mins then its ok again until the next 30 minsÂ*Â* very frustrating Single phase or three phase? |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Clausing Student 2500 / Harrison M300 question | Metalworking | |||
Colchester Master 2500 clutch shaft removal and refitting | Metalworking | |||
Colchester Student Mk 1 - some questions | Metalworking | |||
Colchester Model 6535 Lathe/Opinions Please | Metalworking | |||
$2500 budget on lathe...what should I expect | Metalworking |