Home |
Search |
Today's Posts |
|
Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Turning a pipe without a lathe
I am thinking of concerting my table top drill press into a floor press by replacing the round column with a taller one. I can get a pipe that is close to the same size in stainless, but I would need to somehow turn the ends down where they fit into the top and base approximately .001 to .002.
Any ideas on how this could be done without a lathe? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Turning rings from a pipe | Metalworking | |||
[OT] Just finished my first lathe turning | Woodworking | |||
Turning common pipe | Metalworking | |||
lathe turning | Woodworking | |||
Pen turning with HF 40" lathe | Woodturning |