 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Turning shallow recess - part 3
So here is the recessed plate working:
http://www.flickr.com/photos/2768312...n/photostream/ http://www.flickr.com/photos/2768312...n/photostream/ http://www.flickr.com/photos/2768312...n/photostream/ The double-sided sticky tape was just fine. Facing off remains a bit of a mystery to me. last time I used a similar cutter (BL instead of BR) the finish was somewhat smoother. http://www.flickr.com/photos/2768312...n/photostream/ Hard to tell from the photos. I shall try a different cutter next time. All in all I am pleased with the outcome. Total cost: $3.00 for the aluminum plate and 4 screws. The faceplate was free. Michael Koblic, Campbell River, BC |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Turning shallow recess | Metalworking | |||
| Turning shallow recess- Part 2 | Metalworking | |||
| Segmented turning, An Introduction, part 2 | Woodworking Plans and Photos | |||
| Turning To The Unfamiliar (Part One) | Woodturning | |||
Threaded Mode
