 |
|
| Metalworking (rec.crafts.metalworking) Discuss various aspects of working with metal, such as machining, welding, metal joining, screwing, casting, hardening/tempering, blacksmithing/forging, spinning and hammer work, sheet metal work. |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
Posted to rec.crafts.metalworking
|
|||
|
|||
Turning shallow recess- Part 2
Here is what I did:
http://www.flickr.com/photos/27683124@N07/5562240999/ http://www.flickr.com/photos/2768312...n/photostream/ In the end I did the whole think using a brazed carbide AR bit. I had some issues with holding the 1/2" boring bars Jim W. suggested so I thought I would stick with familiar implements. The diameter is spot on 5.401" - a slip fit for a 5.400" face ring. I shall try turning the ring in this contraption within the next few days. When I have decided whether to go with superglue or double-sided sticky tape :-) Michael Koblic, Campbell River, BC |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Turning shallow recess | Metalworking | |||
| Segmented turning, An Introduction, part 2 | Woodworking Plans and Photos | |||
| Segmented turning, An Introduction, part 2 | Woodworking Plans and Photos | |||
| Turning To The Unfamiliar (Part One) | Woodturning | |||
Threaded Mode
